…Details…

Icon

Thoughts that's escape, only details.

VAX – MMJ DEC423 Pinout

Setting up serial connection to VAXstation 4000/60:

First made a serial cable, attention Vax use a DEC423 serial port designed for long distant terminal line:

--------------- 1 - DTR (Data terminal ready)
I             I 2 - TxD (Transmit data)
I 1 2 3 4 5 6 I 3 - GND (Signal ground)
I             I 4 - RxC (Receive common)
I             I 5 - RxD (Receive data)
---------I____I 6 - DSR (Data set ready)

Pin 2 of the phone connector goes to Rx pin of the serial (3 of DB25 or 2 of DB9), pins 3 & 4 go to ground (7 of DB25 or 5 of DB9), and pin 5 goes to Tx pin (2 of DB25 or 3 of DB9).

Then, make sure that the S3 switch (on the front of the 4000/60) is set to
the up position so that the VAX uses the serial console instead of the
graphics console.

Then, load up your favourite terminal application, set the speed to 9600
baud, make sure hardware handshaking is off, and see if you can talk to
the VAX.

Category: Tech, VMS

Tagged: , , , , ,

Leave a Reply

You must be logged in to post a comment.

Archive